Machining / Layers and Layer Strategies / Managing The Layers Table
In This Topic
    Managing The Layers Table
    In This Topic

    Updating Layer Settings

    To Edit the Layers table use the "Layers" button on the Drawing\Catalog properties "Mach.General | Tools" page.

     

     

    This will launch the Layers Management page:

     

    There are 2 modes of operation on  this page, 'Standard' and 'Advanced'.  The 'Standard' mode is just for viewing the current settings and the 'Advance' for editing.

    Modifying

    Available in Advance mode only:

    1. Pick the relevant Layer name from the dropdown (populated from the Layers Table)
    2. Update the properties as necessary
    3. Press on the 'Save' button
    4. Confirm the modifications are to be saved       

    Note : The modification can be reset by pressing the 'Reload' before saving.

    Adding

    Available in Advance mode only:

    1. Key in a Layer name that does not already exist
    2. Confirm the Layer is to be added
    3. Update the properties as necessary
    4. Press on the 'Save' button
    5. Confirm the modifications are to be saved


    Removing

    Available in Advance mode only:

    1. Pick the Layer to remove from the dropdown
    2. Press the 'Remove' button to the right of the chosen Layer
    3. Confirm the removal

     

    Note : The 'OK', Cancel' and 'Apply' all just exit the page.  Any additions, changes or, removals are done using the appropriate buttons as detailed above.